Operation And Cleaning; Control Descriptions; Use Of The Machine; End-Day Cleaning - Fimar PPN 5 Manuel De Uso Y Mantenimiento

Control descriptions

1) Power-on lamp
Power-on pilot lamp will light.
2) Running lamp
Running pilot lamp will light.
3) Timer
Turn the timer knob to select the required working-cycle time length (0÷4 minutes).
4) Discharge push-button
Press the button to discharge the product after working-cycle.

Use of the machine

Open the transparent lid by pulling the handle A until it clicks
open.
Put the disk in and load the tank with the product to be
processed.
Lock the lid and make sure the outlet door B is locked.
Switch the wall master switch on. Power-on white pilot lamp C
will light.
Start the appliance by turning the timer knob D on the required
working-cycle time length, the running green pilot lamp E will
light.
Make sure rinsing
PPN\PPF\LCN\LCF10-18-PPN\PPF25 this is automatically
accomplished on starting , for models PPN\PPF\LCN\LCF5 the
tap F located on the machine must be turned on manually.
The machine will automatically stop and the running green pilot
lamp will go off on ending the set cycle.
For models PPN\PPF\LCN\LCF5 turn off the water tap F.
In order to let the processed product out open the outlet door B
after putting a container undermeath it.Then press pulse push-
button G to allow the on-empty rotation of the disk. Meanwhile
hold the outlet door so as to check the product comig out
without touching it.
DANGER – CAUTION: never put your hand inside the outlet door to help the product

End-day cleaning

•
At the end of a work day, unplug the machine from the power mains.
•
Thoroughly clean the machine using neutral detergents.
•
Wipe the machine outer parts with a damp sponge.
•
Do not use steel wool or abrasive cleaning products.
water flowing in:
OPERATION AND
for models
come out.
10
CLEANING
3