Pause Mode - NUK BP7 First Choice Manual Del Usario

10520xxx_Rev400_GA_NUK Mipu Tischpumpe BP7.book Seite 31 Donnerstag, 5. April 2018 12:52 12
Nature Sense model: display 34 flashes
(00:00) and the screen background is blue.
Note: The buttons 21 to 25 are touch keys
They only need to be touched lightly to
select the appropriate function.
Starting the pumping session
3. Position the breast shield 9 with the fitted
silicone cushion 10 on your breast so that
your nipple is in the centre of the shield.
Gently press the breast shield in place in
order to ensure a good seal for expressing
your milk. In doing so, take care to keep
the breast milk container 12 attached to
the breast shield in an upright position.
Caution! To ensure the required results,
never allow the milk level to rise beyond
the lower rim of the lip valve 11.
4. To start pumping, touch either of the
buttons 22,
Pumping will start with the fastest suction
rhythm and the lowest suction strength
(default setting).
Setting the suction strength
5. Use the buttons
adjust the suction strength to one of
4 levels.
Touch-and-hold will cause the suction
strength to adjust step by step up to the
maximum or minimum level respectively.
The selected suction
displayed with 31 (First Choice
(Nature Sense).
You can adjust the suction strength any
time during the pumping session.
Setting the suction rhythm
6. Touch the 22 button once to adjust
the suction rhythm to the next level.
Touch-and-hold will cause the suction
rhythm to adjust step by step until you
release the button.
The selected suction rhythm is displayed
with 27 (First Choice
Sense).
23, or 24.
23 and 24 to
strength is
+
) or 38
+
) or 32 (Nature
31
You can adjust the suction rhythm any
time during the pumping session.

Pause mode

7. Touch the Pause button
the pump unit into pause mode. To
continue pumping, touch the Pause
button 25 again.
Memory function
The memory function can be used to save
the sequence of a pumping session from the
moment it is started.
8. To save a pumping session, you must
first change to pause mode by touching
the Pause button
9. Then touch the Memory button
for at least 2 seconds.
While the session is being saved, the
symbol 28 (First Choice
Sense) will flash.
Once the session has been saved, the
pump will return to start-up mode.
10. To start the saved session, touch the
Memory button 21 while the pump unit
is in start-up mode after being switched on.
The symbol 28 (First Choice
Sense) is lit.
Nature Sense model: in addition, the
screen background will change to red.
11. You can pause and resume the pumping
session at any time by touching the Pause
button 25, even while running a saved
session.
12. To exit the Memory function and return to
the default settings for the remainder of the
pumping session, touch either of the
buttons 22,
the pump unit is in pause mode.
This will return your pumping session to
the default settings.
Troubleshooting
13. If you notice a reduction in the suction
power over time, clean the filter 6 (see
"5.3 Special cleaning of tube and filter" on
25 to place
25.
21
+
) or 33 (Nature
+ ) or 33 (Nature
23, or 24 while