Stanley FatMax FME700 Manual De Instrucciones página 8

FENCE OPERATION (FIG. 5, 6)
CAUTION:
To reduce the risk of injury,
turn unit off and disconnect machine from
power source before installing and removing
accessories, before adjusting or changing
set-ups or when making repairs. Be sure the
trigger switch is in the OFF position. An
The fence (E) can be adjusted two ways: to
accidental start-up can cause injury.
change desired cutting angle and to change
spacing between the fence and vise.
TO CHANGE THE DESIRED CUTTING
Use the wrench provided to loosen (do not
ANGLE
remove) the two fence bolts (P). Align the
desired angle indicator line with the slot line
(Q) in the base (D). Securely tighten both
fence bolts before use. For more accurate
square cuts, disconnect the power supply,
loosen the two fence bolts, push arm down
until wheel extends into base. Place a square
against the wheel and adjust fence against
the square. Securely tighten both fence bolts
before use. When making a miter cut, the
vise (F) may not clamp securely, depending
on the thickness of the workpiece and the
miter angle. Other aids (such as spring, bar
or C-clamps) will be necessary to secure the
workpiece to the fence when making these
cuts.
Using the wrench provided, loosen and remove the two fence bolts (P). Adjust the fence
TO CHANGE SPACING BETWEEN THE FENCE AND VISE
(E) to desired locations. Insert both fence bolts in provided locations. Securely tighten both
fence bolts before use.
REMOVAL AND INSTALLATION OF WHEELS (FIG. 7, 8)
CAUTION:
Turn off and unplug the tool
before making any adjustments or removing
or installing attachments or accessories. Be
position. Do not make any adjustment while
sure the trigger switch is in the OFF
the wheel is in motion.
Do not make any adjustment while chop saw is
plugged into power supply.
1. Push in wheel lock lever (L) and rotate
wheel (J) by hand until wheel lock lever
engages slot in inside flange (R) to lock
wheel. Loosen the bolt (S) counterclockwise
in the center of the abrasive wheel with the
included flat wrench (G). Bolt has right-hand
thread.
2. Remove the bolt (S), washer (T), outside
flange (U) and old wheel (J).
Fig. 5
Q
E
Fig. 6
E
D
Q
Fig. 7
8
P
F
P
L