Tabla de contenido
Idiomas disponibles
Idiomas disponibles
• Angled material is best clamped and
MATERIAL CLAMPING AND SUPPORTING (FIG. 2, 3)
cut with both legs resting against
base.
• A spacer block slightly narrower than
the workpiece can be used to
increase wheel utilization (Fig. 2).
• Long workpieces must be supported
by a block so it will be level with top
of base (Fig. 3). The cut off end
should be free to fall downward to
avoid wheel binding.
The vise (F) has a quick-travel feature. To release the vise when it is clamped tightly, turn
VISE OPERATION (FIG. 4)
the crank (H) counterclockwise one or two times to remove clamping pressure. Lift vise
lever (I) up. Pull crank assembly out as far as desired. Vise may be pushed forward into
work without cranking. Lower vise lever (I) then tighten vise (F) on work by using crank (H).
Fig. 4
E
DIAMETER OF WORKPIECE
Fig. 2
DIAMÈTRE DE LA PIÈCE DE TRAVAIL
DIÁMETRO DE LA PIEZA DE TRABAJO
F
WIDTH OF SPACER BLOCK
LARGEUR DE LA CALE DʼÉCARTEMENT
ANCHO DEL BLOQUE ESPACIADOR
Fig. 3
BLOCK
BLOC
BLOQUE
FORWARD
MARCHE AVANT
HACIA ADELANTE
F
7
E
SPACER BLOCK
CALE DʼÉCARTEMENT
BLOQUE ESPACIADOR
CUT-OFF END
EXTRÉMITÉ
COUPÉE
EXTREMO A
CORTAR
I
H
Tabla de contenido
