Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Wear appropriate hearing protection during use. Under some
conditions and duration of use, noise from this product may contribute to hearing loss.
CAUTION:
Spark deflector will get hot. Avoid touching or adjusting while hot. Keep
CAUTION:
cordset and materials away from spark deflector.
Some dust created by power sanding, sawing, grinding, drilling, and
other construction activities contains chemicals known to the State of California to cause
WARNING:
cancer, birth defects, or other reproductive harm. Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products, and
• arsenic and chromium from chemically-treated lumber (CCA).
Your risk from these exposures varies, depending on how often you do this type of work.
To reduce your exposure to these chemicals: work in a well ventilated area, and work with
approved safety equipment, such as those dust masks that are specially designed to filter
out microscopic particles.
• Avoid prolonged contact with dust from power sanding, sawing, grinding,
drilling, and other construction activities. Wear protective clothing and wash
exposed areas with soap and water. Allowing dust to get into your mouth, eyes, or
lay on the skin may promote absorption of harmful chemicals.
Use of this tool can generate and/or disburse dust, which may cause
serious and permanent respiratory or other injury. Always use NIOSH/OSHA approved
WARNING:
respiratory protection appropriate for the dust exposure. Direct particles away from face
and body.
Always use NIOSH/OSHA approved respiratory protection appropriate for
the dust exposure. Direct particles away from face and body.
WARNING:
For your convenience and safety, the following warnings are on your Heavy-Duty 14 inch
(355mm) Chop Saw:
FOR SAFE OPERATION READ THE INSTRUCTION MANUAL.
• DO NOT USE TOOTHED BLADES.
WARNING:
• USE ONLY REINFORCED WHEELS RATED 4300 RPM OR HIGHER.
• WHEN SERVICING USE ONLY IDENTICAL REPLACEMENT PARTS.
• ALWAYS: WEAR EYE PROTECTION, USE GUARDS, CLAMP WORK IN VISE, USE
PROPER RESPIRATORY PROTECTION.
• DO NOT EXPOSE TO RAIN OR USE IN DAMP LOCATIONS.
• An extension cord must have adequate wire size (AWG or American Wire Gauge)
for safety. The smaller the gauge number of the wire, the greater the capacity of the
cable, that is 16 gauge has more capacity than 18 gauge. An undersized cord will cause
a drop in line voltage resulting in loss of power and overheating. When using more than
one extension to make up the total length, be sure each individual extension contains at
least the minimum wire size. The following table shows the correct size to use
depending on cord length and nameplate ampere rating. If in doubt, use the next
heavier gauge. The smaller the gauge number, the heavier the cord.
Volts
120V
240V
Ampere Rating
More
Than
0
-
6
-
10
-
12
-
Minimum Gauge for Cord Sets
Total Length of Cord in Feet
0-25
26-50
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
0-50
51-100
(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
Not more
American Wire Gage
Than
6
18
16
10
18
16
12
16
16
16
14
12
51-100
101-150
101-200
201-300
16
14
14
12
14
12
Not Recommended
4
Tabla de contenido
