Preparation And Taking Into Operation; Inserting Rechargeable Batteries - Reiner 940 Instrucciones De Empleo

REINER 940
Disposal
Defective or flat batteries
Flat batteries of rechargeable batteries must not be disposed of in the household
waste.
Electrical and electronic waste devices
Waste devices must not be disposed of in the conventional household waste. They
must be returned to a special collection point for recycling of electrical and electro-
nic devices.

1. Preparation and Taking into Operation

1.1. Commissioning
The rechargeable batteries must be charged completely before the first use.
The charging time is approx. 3 hours. The rechargeable batteries are charged when the
green charge display

Inserting rechargeable batteries

Always replace all rechargeable batteries at once. Date, time and counter reading of the
numbering machine are retained when the rechargeable batteries are removed.
Open the rechargeable battery compartment
f
Be careful to insert the rechargeable batteries the correct way round (+/- polarity).
Close the rechargeable battery compartment
f
Charge batteries
Only connect the device to the PC when the PCset graphic-Software was installed.
Installation of the PCset graphic software installs the required USB drivers. The USB
drivers are automatically recognised and loaded when the device is connected to the
computer. The device driver installation fails if the device is connected without the
PCset graphic software being installed.
Charging at a USB hub without dedicated power supply is not possible.
Connect Micro-USB of the device
f
Green charging indicator
9
2
goes out.
Fig.

Fig.
A

4
to the mains unit with the USB cable and connect the.
2
lights up.
B
5
in the direction of the arrow.
5
.