Safety Instructions; Standards & Regulations - VWR 5000I Manual De Instrucciones

s I
afety nstrUctIons
Please read the entire instruction manual before operating the Incubating Orbital
Shaker.
WARNING! DO NOT use the Incubating Orbital Shaker in a hazardous atmo-
sphere or with hazardous materials for which the unit was not designed. Also,
the user should be aware that the protection provided by the equipment may
be impaired if used with accessories not provided or recommended by the
manufacturer, or used in a manner not specified by the manufacturer.
Exercise extreme caution when moving the unit, there is a risk of pinching or
crushing fingers.
Always operate unit on a level surface for best performance and maximum
safety.
DO NOT lift unit by the tray, front bezel or lid.
CAUTION! To avoid electrical shock, completely cut off power to the unit by
disconnecting the power cord from the unit or unplug from the wall outlet.
Disconnect unit from the power supply prior to maintenance and servicing.
Spills should be removed promptly. DO NOT immerse the unit for cleaning.
DO NOT operate the unit if it shows signs of electrical or mechanical damage.
CAUTION! The caution hot indicator light warns that the temperature of the air in
the chamber is above 40°C. The light will illuminate and remain lit when the
temperature of the air in the chamber reaches approximately 40°C. When the
heat is turned off, the caution hot indicator light will stay lit until the temperature
of the air in the chamber is less than 40°C.
Earth Ground - Protective Conductor Terminal
Alternating Current
3
s & r
tandards egUlatIons
VWR international hereby declares under its sole responsibility that the products
comply with the requirements of the following directives and associated standards:
Associated EU directives:
EMC directive 2004/108/EC
LVD directive 2006/95/EC
ROHS directive 2011/65/EU
WEEE directive 2002/96/EC
Safety standards:
EN 61010
EN 61010-2-051
EN 61010-2-010
UL 61010-1
CAN/CSA C22.2 No. 61010-1-04
EMC standards:
EN 45501 EN 61000-4-3
EN 55022A EN 61000-4-4
EN 6100-3-2 EN 61000-4-5
EN 6100-3-3 EN 61000-4-6
EN 61000-4-1 EN 61000-4-11
EN 61000-4-2
EN