Kenmore 790.4061 Serie Manual De Uso página 22

OCCURRENCE
Oven light does not work.
Fan noise during cooking
operation.
Oven smokes excessively during
broiling.
Poor baking results.
Self-cleaning cycle does not
work.
Soil not completely removed
after self-cleaning cycle is
completed.
Flames inside oven or smoke
from vent.
Before You Call
POSSIBLE CAUSE/SOLUTION
Burned-out or loose bulb. Follow the instructions under Changing Oven Light to replace or tighten
the bulb.
A cooling fan may automatically turn on and off to cool internal parts. This is normal, and the fan
may continue to run even after oven is turned off.
Oven door is closed. Door should be open during broiling.
Meat too close to the broiler unit. Reposition the rack to provide more clearance between the meat
and the broiler. Preheat broil element for quick searing operation.
Meat not properly prepared. Remove excess fat from meat. Slash remaining fatty edges to prevent
curling, but do not cut into the lean.
Grid on broiler pan wrong side-up. Grease does not drain into your broiler pan. Always place the
grid on your broiler pan with the ribs up and the slots down to allow grease to drip into the pan.
Broiler pan used without grid or grid cover with foil. DO NOT use your broiler pan without the grid
or cover the grid with foil.
Oven needs to be cleaned. Grease has built up on oven surfaces. Regular cleaning is necessary
when broiling frequently. Old grease or food spatters cause excessive smoking.
many factors affect baking results. See Baking for hints, causes and corrections. See Adjusting
Oven Temperature.
Make sure the oven door is closed.
Controls not set properly. Follow instructions.
Self-cleaning cycle was interrupted. Stop time must be set 2-4 hours past the start time. Follow
steps under «Stopping or Interrupting a Self-Cleaning Cycle» in this Use & Care Guide.
On a dual cavity model, one oven is in operation. If one oven is set for any mode, the second oven
cannot be set to CLEAN.
Failure to hand clean frame of oven or door area outside oven seal. These areas are not in the self-
cleaning area, but get not enough to burn on residue. Clean these areas before the self-cleaning
cycle is started. Burned on residue can be cleaned with a stiff nylon brush and water or a nylon
scrubber. Do not clean the oven door gasket or it will be damaged.
Excessive spillovers in oven. Set the self-clean cycle for longer cleaning time.
Excessive spillovers in oven. This is normal, especially for high oven temperatures, pie spillovers or
for large amounts of grease on bottom of oven. Wipe up excessive spillovers.
22