Idiomas disponibles
Idiomas disponibles
InSTAllATIon
Table of Contents
6 Remove the Card from its protective antistatic packaging
Handle it by the metal bracket and do not touch the gold edge
connectors Insert the Card into the PCIe slot, carefully aligning
the rear bracket to the computer case Make sure the Card's
edge is fully inserted into the slot and screw down the bracket
(see image below)
note: When installing the Card, please take extra care to avoid
touching the components or the edge connector of the board (the
portion which is inserted into the PCIe slot)
SuperSpeed USB 3.0 2-Port PCI Express
seCTions
1
X1 Add-In Card
®
2
7 Locate a free 4-pin Molex power connector from your
computer's power supply and plug it into the Card
note: If you do not have a free 4-pin Molex connector, or have
one that cannot reach the location of the Card, use the extended
Molex Y-Splitter supplied with your Card
8 After installing the Card, replace the outer cover and turn on
the computer
note: Do not plug any devices into the Card until driver
initialization is completely finished.
9. Windows will now initialize drivers for "Universal Serial Bus
Controller" and complete the installation automatically You will
receive a message stating, "Your hardware is ready to use "
note: Depending on the speed of your computer, it may take up
to 30–60 seconds for the Card to be detected
The installation procedure is now complete
6
3
4
Capítulos
