Loading Of Default Parameters; Self-Learning Of Working Times - V2 FORTECO Manual De Instrucciones

LOADING OF DEFAULT
PARAMETERS
If necessary, it is possible to restore all the parameters to their
standard or default value (see table at the end)
WARNING: This procedure causes the loss of all the
customized parameters, therefore it has been put outside the
configuration menu, to reduce the possibility of executing it by
mistake.
1. Keep the wheel pressed until the display shows -dEF
2. Release the wheel: the display shows ESC (press the wheel
only if it is needed to exit this menu)
3. Push the wheel downwards: the display shows dEF
4. Press the wheel: the display shows no
5. Push the wheel downwards: the display shows Si
6. Press the wheel: all the parameters are rewritten with their
default value and the display visualizes the control panel.
SELF-LEARNING OF WORKING
TIMES
This menu allows the automatic learning of the times necessary
to open and close the gate.
During this phase, the control unit memorizes also the forces
necessary to open and close the gate: these values will be
activated by using the obstacle sensor.
WARNING: before proceeding, check that the limit
switches have been installed in the correct position.
1. Keep the wheel pressed until the display visualizes -APP
2. Release the wheel: the display shows ESC (press the wheel
only if it is needed to exit this menu)
3. Push the wheel downwards: the display shows t.LAv
4. Press the wheel to start the self-learning cycle of the working
times:
• the gate is activated in closure until reached the closure
limit switch
• the gate is activated in opening until reached the opening
limit switch
• the gate is activated in closure until reached the closure
limit switch
• Once ended the cycle, the control unit memorizes the
obtained operating times, then the display visualizes the
value suggested for the obstacle detector: if any operation
is made for 20 seconds the control unit exits the
programming phase without saving the suggested value.
• To change the value, push the wheel downwards or
upwards, then, to save the value, press the wheel: the
display visualizes SEnS. Push the wheel downwards until
the display visualizes FinE, then press the wheel, select the
item Si and press again the wheel: the display visualizes the
control panel
39