Motor Overriding System; Installation Layout - V2 FORTECO Manual De Instrucciones

MOTOR OVERRIDING SYSTEM

In case of absence of current, the gate can be released by
operating on the motor:
1. Open the hatch of the lock J in front of the motor
2. Insert the key K in the lock and turn clockwise to open the
hatch of the release on the side
3. Insert the key L into the hole and turn clockwise until reached
the limit switch
To restore the automation, proceed as follows:
1. turn the key L anticlockwise until reached the limit switch,
then draw it out
2. turn the key K anticlockwise closing the hatch of the lock,
then draw it out
3. Close the lock with the hatch J
WARNING: ALL THE CABLES USED FOR THE INSTALLATION MUST BE MARKED WITH T100°C.
Power supply
Blinker
External Aerial
Digital or key selector

INSTALLATION LAYOUT

cable 3 x 1,5 mm 2
cable 2 x 1,5 mm 2
cable RG-58
cable 3 x 0,5 mm 2
Internal Photocellules
External Photocellules
Safety edge (EN 12978)
32
cable 4 x 0,5 mm 2 (RX)
cable 2 x 0,5 mm 2 (TX)
-