Set-Up Of Operational Parameters; Memorization Of Remote Controls; Deleting Remote Controls - V2 AZIMUT Manual De Instrucciones

SET-UP OF OPERATIONAL PARAMETERS

AZIMUT is equipped with a
practical interface that allows
rapid and simple on-display
programming using four keys:
, , +, and -.
Follow the instructions below carefully in order to configure the
parameters correctly.
1. Set-up of opening limit
Press the key for 5
seconds. The device will
beep and the display will
show 1.
Using the + and - keys, move
the door to the maximum
open position.
Press the key to memorize this parameter and proceed to
the next. The display will show 2.
2. Set-up of closing limit
Using the + and - keys, move
the door to the maximum
closed position.
Press the key to
memorize this parameter and
proceed to the next.
The display will show 3.
3. Learning Forces
Press the + key:
the door opens.
When it reaches the limit,
press the - key:
the door closes.
During this phase, the device will learn all of the force levels
necessary to open and close the door.
Press the key to memorize this parameter and proceed to
the next. The display will show 4.
4. Adjust the sensitivity
This menu allows the
sensitivity of the device to be
increased or decreased when
the door meets an obstacle.
This parameter is already set
to an average value (4) which
should be optimal for most
installations.
The various levels are shown as follows:
0
-
5. Select the remote control buttons
This menu allows the
selection of the buttons to
control the actuator. This
function can be useful
i
should it be desirable to
control 2 actuators using the
same remote control, but
with different buttons.
2
Press the - key to select button 1, the display will
show:
Press the - key to select button 2, the display will
show:
3
Thereafter, to exit the programming, hold the
5 seconds: the display will show
actuator is ready for use.

MEMORIZATION OF REMOTE CONTROLS

1. Press key
2. Release key
the remote control button
twice: the device emits a
4
BEEP and the dot is
turned off to confirm
storage in the memory
has occurred
3. Repeat the procedure for the other remote controls to be
memorized.

DELETING REMOTE CONTROLS

1. Press and hold key
appears on the display.
2. Hold the key until the dot on the display is turned off: the
remote controls have been deleted.
15
0 0 0
1 2 3
until the dot appears on the display.
and press
: after approx. 1 second the dot
0 0 0
4 5 6
+
5
8
8
key pressed for
0
and will go into standby. The
0