Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Figure 2
Extension
Transmitter
Microphone
3. Note: The transmitter can be oriented horizontally or vertically. Tempo-
rarily place the Extension Transmitter in the intended mounting position.
Press the Test Button. If the plug-in chime sounds, continue with step 4. If
the plug-in chime does not sound, go to the Troubleshooting section be-
fore continuing with step 4.
4. With the Extension Transmitter still in the intended location, activate the
existing door chime. If the plug-in chime sounds, proceed to step 7. If it
does not sound, try different positions for the transmitter, or increase the
microphone sensitivity (Figure 3) by turning the Microphone Sensitivity
Adjustment clockwise. In some instances, it may be necessary to take the
removable microphone out of the transmitter case, and mount it directly
on the existing chime case or inside the existing chime case on a resonat-
ing chamber (not on chime bars). Please note–the microphone wires can
be temporarily removed from the wire terminals (Figure 3) by loosening
the terminals with a phillips screwdriver if wire routing through small open-
ings in the existing chime cover is desired. There is a slot on the transmit-
ter cover for the wires if an external mounting is required. Double-sided
tape is provided to attach the microphone to your existing chime case.
3.
Install the Extension Transmitter.
1. Remove the battery cover from the Extension
Transmitter by pressing on the cover with your
thumb, then slide the cover off as shown Figure 2.
2. Install four AAA batteries (not provided). Make
sure batteries are oriented properly (see page 5).
Microphone
Wire Terminals
Figure 3
Microphone Sensitivity
Adjustment
-2-
Test Button
Transmit
Light
Existing
Doorbell
595-5345-06
Tabla de contenido
