Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ON
ON
1 2
1 2
ON
ON
1 2
1 2
Push
Chime
Button
Setting
Setting
Figure 3
0
30 Sec.
0
20 Sec.
Figure 4
207351-01
Step A2 (see Figure 4)
• Unplug chime or remove chime batteries. Wait 30
seconds.
• Press and hold the push button within 20 seconds
after restoring power to the chime (plug in the chime
or install chime batteries). When the "Ding-Dong" tune
is played, the push button is synced with the chime.
• Go to step 4.
Syncing Chime < B >
Step B1 (see Figure 5)
• Set push button switch 1 to ON. Go to step B2.
Step B2 (see Figure 6)
• Press and hold the button on the chime until the chime
sounds a "Beep-Beep".
• Press the push button within 30 seconds. The chime will
sound a "Beep-Beep" tone to indicate the push button
is synced. Wait 30 seconds before pressing the push
button to ensure operation.
• Go to step 4.
Syncing Chime < C >
Step C1 (see Figure 7)
• Set push button switch 1 to ON. Remove all jumpers
from positions 1 through 7 on the chime and place
jumpers only on positions 1 and 2, or set switches 1
and 2 to the ON position and switches 3 through 7 to
the OFF position.
• Go to step 4.
-3-
Continued
Tabla de contenido
