Weston PRO Serie Manual De Instrucciones página 8

GRINDER ASSEMBLY INSTRUCTIONS
WARNING!
Before cleaning, assembling or disassembling the
Grinder, make sure the Grinder Motor is OFF and the PLUG IS REMOVED
FROM THE OUTLET/POWER SOURCE!
1. Insert the Head into the Gear Housing
with the Feed Chute facing straight up. You
will need to line up the slot in the Head with
the Pin inside the Gear Housing. Be sure the
Head is seated fully into the Gear Housing
.
(Figure 1)
2. Tighten the Head Locking Knob to lock
the Head into place.
3. Insert the Auger, with the Auger Bearing
attached, into the Head
(Figure 2)
Auger Splines with the Drive Shaft of the
Grinder.
NOTE: Periodically inspect the Auger
Bearing for wear. If the Auger Bearing is
worn excessively, replace it immediately or
Head damage could result.
4. Place the Knife onto the square portion
of the Auger Pin . Be sure the blades
(Figure 2)
of the Knife are facing outward.
5. Place one of the Grinder Plates onto the
Auger Pin; align the notch in the Grinder
Plate with the Pin in the Grinder Head.
6. Install the Front Ring Nut, DO NOT
OVERTIGHTEN. Turn the Front Ring Nut
until it makes contact with the Grinder Plate,
then make 1/4 turn more to tighten into place.
WARNING!
NEVER operate Grinder without the
Tray/Safety Guard secured in place.
To avoid serious or fatal injury, NEVER reach
ALWAYS use the Stomper to push meat
Read & fully understand all instructions
Slot in Head
Feed
Chute
Head
. Align the
Auger Splines
Auger
Auger Pin
Knife
Grinder Plate
Front Ring
Nut
into any Grinder inlet.
into the Grinder Head.
& warnings prior to use.
-8-
FIGURE 1
Gear
Housing Head Locking
Knob
FIGURE 2
Head
Auger Bearing
NOTE! Be sure the blades
of the Knife are facing out.