Display Light Control; Language Selection; Run Duration (Speeds 3 And 4 Only); Password Protect - Zodiac JEP-R Manual De Instalación Y Operación

ePump™ and VS-FloPro™ Variable-Speed Pump Controller
5.5

Display Light Control

The controller's display is equipped with a backlight to aid
viewing in low light conditions.
From the setup menu, select DISPLAY LIGHT. Press
MENU. Using the arrow keys, select the desired operating
mode for the display backlight:
LIGHT OFF: Turn off display backlight.
LIGHT ON: Turn on display backlight.
2 MIN TIMEOUT: Turn on display backlight, with automatic
turn-off after two (2) minutes since the last key press.
5.6

Language Selection

From the setup menu, select LANGUAGE using the arrow
keys. Press MENU. Using the arrow keys, select the desired
language. Press MENU to save the selection.
5.7

Run Duration (Speeds 3 and 4 Only)

Speeds "3" and "4" may be programmed to run for a specified
duration after being manually started. This run duration
is programmable from 30 minutes to eight (8) hours, in
increments of 30 minutes. A setting of 0:00 disables the run
duration feature, allowing the speed to run indefinitely.
From the setup menu, select RUN DURATION. Press
MENU. Using the arrow keys, select the speed to be
programmed. Press MENU. Set the desired run duration for
the speed using the arrow keys. Press MENU to accept.
|
Installation Manual
5.8

Password Protect

Entry into the USER SETUP MENU may be restricted by
the setting of a four-digit password.
NOTE: There is a 10-minute delay period from the last
key press to the password becoming active. This allows
additional, protected operations to be performed temporarily
after setting the password.
From the setup menu, select PASSWORD PROTECT and
press the MENU key.
The menu will verify if the user wishes to set a password.
Using the arrow keys, select YES then press the MENU key.
Using the arrow keys, select a value for each password digit.
Press the MENU key to set each digit.
When the last password digit is set, the password is stored
and the controller displays *PASSWORD ACCEPTED* and
returns to the OFF mode.
SELECT USER SETUP
PASSWORD PROTECT
Changing a Password
From the setup menu, select SET PASSWORD and
press the MENU key. The controller displays CHANGE
PASSWORD? Using the arrow keys, select CHANGE and
press the MENU key.
The current password is displayed. Using the arrow keys,
select a value for each password digit. Press the MENU key
to set each digit. When the last password digit is set, the
password is stored and the controller displays *PASSWORD
ACCEPTED* and returns to the OFF mode.
CHANGE PASSWORD?
CHANGE
Clearing A Password
From the setup menu, select SET PASSWORD and
press the MENU key. The controller displays CHANGE
PASSWORD? Using the arrow keys, select CLEAR
and press the MENU key. The password is cleared and the
controller returns to the OFF mode.
ENGLISH
Page 17