Tv Operation - memorex MLT1912 Guia Del Usuario

1
Press the STANDBY button 1 to turn on the TV; the
STANDBY indicator will turn off. Press the SOURCE
button 2 to select the desired mode, TV(NTSC) or ATSC.
3
3
4
1
2
NOTES:
• For NTSC, when the Reception option is set to TV, only channels up to 69 can be selected. When set to CATV,
channels up to 125 can be selected.
• If an invalid channel is selected, the display will revert to the original channel.
FAQs:
Why do I only receive 69 channels, when my cable goes much higher?
For NTSC, reception option must be set to CATV when using cable, see page 16.
Why are some channels scrambled?
You must subscribe to these channels through your cable company.

TV OPERATION

1
2
For proper operation, before selecting channels, they must be set into the
TV's program memory, see page 17.
Press and release the CHANNEL/Navigation UP 1 or DOWN 2 button. The TV
automatically stops at the next channel set into memory. This will not operate if
channels are not set into memory.
TV (NTSC) Direct Channel Selection/Number (0-9) buttons 3
Use these buttons to select a channel. The channel number will appear at the top
right corner of the screen. Simply enter the 1, 2 or 3 digit channel number.
ATSC Direct Channel Selection/Number (0-9) buttons 3
Use these buttons to select a channel. The channel number will appear at the top
right corner of the screen.
• Enter the main channel number, then the -/-- button 4, then enter
the sub-channel.
2
Adjust the volume level by pressing the VOLUME
UP/Navigation Right 1 or VOLUME DOWN/Navigation Left
2 button. The volume level will be indicated on the bottom
of the screen.
22
2
1