Transport, Putting Into Operation, Assembly And Decommissioning; Transport; Assembly (Ebs-T/53-37 Only) - Hupfer OTA/47–36 Manual De Instrucciones

Transport, Putting into Operation, Assembly and Decommissioning

Transport

4 Transport, Putting into Operation, Assembly and Decommis-
sioning
4.1 Transport
ATTENTION
4.2

Assembly (EBS-T/53-37 only)

The following section describes the assembly of the built-in appliance.
NOTE
Figure 6
Step 1: Preparation
Prepare cut-outs in the worktop corresponding to the indicated dimensions.
The worktop cut-out dimensions are given in mm as shown in the drawing.
Remove the protective plastic film from the metal plates.
4330041_A0 OTA/47–36 | OTA/53–37 | OTA/58-33 | OTA/53–37 S | OTA/U-BW | OTA-E/BA-4xGN | TAG-1/53-37 | TA-2/53-37 | EBS-T/53-37
Damages caused by improper transport
In the case of off-site transport in a vehicle such as a lorry, the appliances
should be secured properly. The total brakes are not sufficient as a transport
securing method.
If the appliances are not secured properly, there is a risk of damage to prop-
erty and persons caused by squashing.
During transport, secure all the individually standing appliances using corre-
sponding transport securing devices.
Appliance location
Built-in appliances may only be used after being retrofitted or built-in (e.g. in a
cabinet).
Worktop cut-out EBS-T/53-37
Chapter 4
Page 19
Tray dispenser