Transport, Assembly, Putting Into Operation And Decommissioning; Transport; Assembly; Unheated Appliances (Ebr/70-120 | Ebr/100-150) - Hupfer EBR/70-120 Manual De Instrucciones

Transport, Assembly, Putting into Operation and Decommissioning

Transport

4 Transport, Assembly, Putting into Operation and Decommis-
sioning
4.1 Transport
ATTENTION
4.2

Assembly

The following section describes the assembly of the cup dispenser.
Primarily, the unheated appliances EBR/70-120 and EBR100-150 are described that do not require any elec-
trical installations after the assembly.
Subsequently, there follows the assembly description of the heated appliances EBRH/70-120 and
EBRH/100-150, that must be connected to the power supply after the assembly.
4.2.1

Unheated appliances (EBR/70-120 | EBR/100-150)

NOTE
Figure 3
Step 1: Preparation
Prepare the worktop cut-out.
The cut-out dimension for the EBR/70-120 is 15.2" (385 mm) (diameter).
The cut-out dimension for the EBR/100-150 is 17.9" (455 mm) (diameter).
Remove the protective plastic film from the metal plates.
91285809_A0
Appliance damages caused by improper transport
In the case of off-site transport in a vehicle such as a lorry, the appliances
should be secured properly.
If the appliances are not secured properly, there is a risk of damage to prop-
erty and persons caused by squashing.
During transport, secure all the individually standing appliances using corre-
sponding transport securing devices.
Appliance location
Built-in appliances may only be used after being retrofitted or built-in (e.g. in a
cabinet).
Worktop cut-out
EBR/70-120 | EBR/100-150 | EBRH/70-120 | EBRH/100-150
Chapter 4
Page 13
Cup Dispenser