Additional Information - Nice TT2L Instrucciones Y Advertencias Para El Instalador

3.2) Settings via the programming pushbutton
To memorize a transmitter via the programming pushbutton proceed as described below.
Table "A3" Memorizing of a transmitter in mode I
1. Press and hold down the programming button for at least 4 seconds.
2. Release the programming button when the LED lights up.
3. Within 10 seconds, press and hold down for at least 3 seconds key 1 0r 2 (or key 3 or 4)
of the transmitter to be memorized.
4. If the memorization procedure is successful, the led emits 3 long flashes.
Note. If there are other transmitters to be memorized, repeat point 3 within a further 10 seconds; the memorization phase terminates if no
new transmitters are received within a 10 second interval.
If you need to clear the memorization and programming operations, follow the steps described below.
Table "A4" Memory deletion
1. Press and hold the programming pushbutton
2. Wait for the led to illuminate, then wait for it to turn off, followed by a flashing sequence.
3. Release the pushbutton precisely during the third flash to delete the memorized
transformers only, or during the fifth flash to delete the entire contents of the
memory.
4. If the memory clearing procedure has been successful, the led will flash 5 times.

4) Additional information

In addition to the FLO2R, VERY VR and NICEWAY series transmitters, the TT2L and TT2D control units also recognise other transmitters
produced by Nice (paragraph 4.1 Compatible transmitters). A particular command can also be associated to each transmitter key by means
of a specific memorization procedure (paragraphes 4.2.1 Mode I and 4.2.2 Mode II).
4.1) Compatible transmitters
Table A5 indicates the transmitters and relative type of code that can
be used with the TT2L and TT2D control units.
Table "A5"
Coding
ERGO1 - ERGO4 - ERGO6
PLANO1 - PLANO4 - PLANO6 - PLANO TIME
FLOR Rolling code FLO1R - FLO2R - FLO4R
NICEWAY
VERY VR
SMILO Rolling code SM2 - SM4
FLO1 - FLO2 - FLO4
FLO Fixed code
VERY VE
Because the coding of the transmitters is different and the control unit is unable to recognise them at the same time, the first transmitter
memorized determines the type of coding in use and therefore the type of transmitters that can be memorized afterwards. If it is necessary
to change the type of transmitter after the first transmitter has been memorized, all transmitters must be cleared (see table A4).
The type of code can be checked by the number of flashes emitted by the led on start-up.
Led flashes
1 short flash (total 0.2s)
2 short flashes (total 0.4s)
3 short flashes (total 0,6s)
2 long flashes (total 1.5s)
4.2) Memorization of the transmitters in Mode I and Mode II
Tables A1, A2 and A3 describe the memorization of the transmitters in Mode I, where a pair of keys is used on each transmitter: 1-2 or 3-4.
The transmitters can also be memorized on the TT2L and TT2D using Mode II, which allows greater flexibility in the use of the transmitter
keys. Transmitters can be memorized using both Mode I and Mode II on the same control unit.
Transmitters
Code type of memorized transmitters
Transmitters with FLO code
Transmitters with FLOR code
Transmitters with SMILO code
Memory empty (no transmitter memorized)
ERGO PLANO
FLO4R VERY
Example
4s
3s
Example
( )
NICEWAY
SM4 SM2
5
GB