CAME Z Serie Manual De Instrucciones página 23

ENGLISH
After setting the slow down spacing (ref. C fi g. 3) with the "adjust microswitches" procedures shown in
the gearmotor's manual...
...prepare a 60x30 mm template - and hold it up against one of the two mechanical stops as shown in
fi g. 1 (adjustment is to be made either on the closing endstop or opening endstop).
Activate the gate - either using a command button or the remote control - and turn the OP TIME (TL)
trimmer clockwise until the gate leaf inverts its direction just as it touches the obstacle/template.
Then turn the template from its short side (fi g. 2) and check that the gate leaf stops against the obsta-
ble/template. Otherwise activate the trimmer clockwise.
fi g. 1
fi g. 2
fi g. 3
ADJUSTING THE STOP ZONE
A = Amperometric sensor's operating area with
inverted movement
B = Normal speed operating area
C = Slowdown speed operating area
D = Amperometric sensor's operating area with
stopped movement
E = Closing and opening endstops
OP TIME
-23-