Preparation For Welding - Helvi MULTITECH 365 Manual De Uso

Mma/mig-mag/tig multifunction welder soldadora de hilo multifunción mma/mig/tig
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

TROLLEY MOUNTING AND INSTALLATION
Follow the mounting instructions supplied with
the trolley to install the welding unit, compact
or with separate wire feeder and the cooling
unit.
HOSEPACK CONNECTION
Connect the dinse plugs of the interconnec-
ting hosepack to the Positive Sockets -
the back side of wire feeder and power gene-
rator.
Connect the military connectors of the inter-
connecting hosepack to the Sockets -
the back side of wire feeder and power gene-
rator.
Connect the blue water feed hose of the in-
terconnecting hosepack to the connections
marked in blue -
feeder and water cooler.
Connect the red water feed hose of the in-
terconnecting hosepack to the connections
marked in red -
feeder and water cooler.
Load the wire, connect the gas cylinder and
replace the flexible if necessary, as described
in this paragraph.
Check line voltage and connect power cable.
Power the welding unit ON. The display shows
the screen of the last welding process perfor-
med by the unit.
EARTH CABLE AND TORCH CABLE
CONNECTION
Ensure unit is powered off and unpluged
from the mains.
Figure 1 - Voltage Change
ASSEMBLY
- on the back side of wire
O
- on the back side of wire
O

PREPARATION FOR WELDING

WATER COOLER CONNECTION
Important: read also the Operating instruc-
tions supplied with the water cooler before
connecting it to the welding unit.
Connect the power cable and the pressostat
cables to the connectors on the back panel of
the unit located inside the compartment -
- on
J
Important: The water cooler is activated
from the menu "Basic Setup". Refer to "Ba-
sic Setup" section.
- on
I
NO-GAS WELDING (MOG)
Connect the earth cable to the positive cur-
rent socket – B – of the power source.
Connect the torch connection cable to the ne-
gative socket on the Voltage change board
on the horizontal internal panel.
GAS WELDING (MAG)
Connect the earth cable to the negative cur-
rent socket – E – of the power source.
Connect the torch connection cable to the po-
sitive socket on the Voltage change board on
the horizontal internal panel.
Plug the torch hose into the socket – A –
on the front of the welder having care to not
damage the contacts and secure by hand
screwing in the threaded connection.
- .
R
5
Tabla de contenido
loading

Este manual también es adecuado para:

Multitech 465Multitech 505

Tabla de contenido