Description (Fig. A) - Ferm JSM1026 Traducción Del Manual Original

exposure to vibration when using the tool for the
applications mentioned
- using the tool for different applications, or with
different or poorly maintainted accessories,
may significantly increase the exposure level
- the times when the tool is switched off or when
it is running but not actually doing the job, may
signifi cantly reduce the exposure level
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns

DesCriPtiOn (fig. a)

Your jigsaw has been designed for sawing wood,
metal, plastics, ceramics, rubber, etc. to any
required size and in any required shape.
1. On/off switch
2. Lock off button
3. Saw blade holder
4. Saw shoe
asseMBLy
Before assembly, always switch off the
machine
The battery must be charged before firstuse.
Removing the battery from the machine
• P ush the battery unlock buttons and pull the
battery out of the machine
Inserting the battery into the machine
Ensure that the exterior of the battery is clean and
dry before connecting to the charger or machine.
• I nsert the battery (2) into the base of the
machine
• P ush the battery further forward until it clicks
into place.
Charging the battery (with the charger)
• P lug the charger plug into an electrical outlet
and wait for a while. The LED indicator will
lighten up and show the charging status.
LeD Charger status
Red Battery charging in progress
Green Battery charging finished, battery fully charged
• F ully charging the 1.5Ah battery may take up
to 240 minutes.
• A fter the battery is fully charged remove the
charger plug from the outlet and remove the
battery from the charger.
When the machine is not being used
over a longer period of time it is best to
store
Mounting and removing the saw blade (fig. B)
Refer to the table below to select the required saw
blade.
saw blade
Coarse
Medium
Fine
Very fine
Do not attempt to remove the guard from
the machine.
fitting a saw blade
fig. B
The machine is equipped with a quick fit system.
• T urn the clamping ring (13) of the saw blade
holder as far to the left as possible and hold it
there.
• P lace the saw blade in the blade holder.
• L et go of the clamping ring.
• M ake sure when changing the saw blade
that the blade holder is free of material debris
(such as splinters of wood or metal).
• B efore use, always check that the saw blade
is securely fixed.
removing the saw blade
• T urn the clamping ring of the saw blade holder
as far to the left as possible and hold it there.
• R emove the saw blade from its holder.
• L et go of the clamping ring.
Material
Wood
Wood
Steel, aluminium, plastic
Wood (curves)
5
EN