Charging - Silvercrest SRR 3.7 B2 Instrucciones De Servicio

5. Charging

NOTES:
• Before the device is used for the first time, and during the fol-
lowing three charging procedures, the device should be
charged for 90 minutes in each case.
• The capacity/charging state of the battery 10 is displayed
in percent (00, 05, 10, ... ,100% in increments of 5%).
• When the batteries are almost empty, the plug symbol 11
flashes in red. The device can then only be used for a short
time without being connected to the electricity supply.
• It takes about 5 minutes to charge the device sufficiently for
one shave.
• When the battery is fully charged, the device can be used
for approximately 60 minutes without being connected to the
power supply.
1. Switch off the device with the on/off switch 9 if necessary.
2. Connect the power unit 19 to the connection 14 at the de-
vice.
3. Insert the power unit 19 into a readily accessible wall sock-
et whose voltage matches the voltage stated on the rating
plate.
4. The plug symbol 11 is lit red and the battery is charged.
When the battery is fully charged, 100% is displayed.
When the battery is fully charged, the device can be used
for approximately 60 minutes without being connected to
the power supply.
39
GB