Battery Installation; Sleep Mode - Napa CARLYLE ETW12FL Instrucciones De Operación

REPLACING THE HEAD KIT (CONT.)
Step 8: Fasten the lid to the ratchet head with lid screws.
See Fig. 8
Test the functionality by making sure the driver turns and
the switch can pivot in both directions.
BEFORE USING THE WRENCH

BATTERY INSTALLATION

• Remove the battery cap.
• Insert two AA batteries (provided) matching the
-/+ polarities of the battery to the battery
compartment.
• Replace the battery cap and fasten it tightly
according to the illustrations.
SET UP
1. Power On/Clear
2. Unit/Setting
3. Up/Down

SLEEP MODE

• The wrench will automatically go into "Sleep" mode after
being idle for 5 minutes to save power.
Press to wake from "Sleep" mode.
RESETTING THE WRENCH
• If the wrench does not function normally,
Press at the same time to reset the wrench.
ETW12FL, ETW14FL, ETW38FL
Fig. 8
1 2
6
+
-
+
Battery and Cover
3
-
Rev. 02/11/13