Pulmic ANIMAL TRACK Manual De Instrucciones página 14

VACCINATION PROCEDURE
To proceed to vaccination have to follow the technical specifications that are
available below:
1. Adjust the height of the spray bars to match every level of the batteries.
(Approximately 0.5 m). The nozzle should be positioned approximately at the
height of the roof of the cage.
2. Activate the switch keeping three valves open, the return and the distributing
the product to each spray bar for 15 seconds. Then regulate with the return
regulator valve to the desired working pressure.
3. The working pressure must be 6 bars for nozzles of thin droplet (green
cap / nozzle purple) and 3 bars for nozzles of coarse droplet (yellow cap /
nozzle lilac).The pump includes a pressure switch which operates when the
pressure exceeds 9 bars, protecting and shutting down. To achieve the required
pressure will have to open or close the return valve (central).
4. Work constant pass of 0.8 to 1 m / s. Test is recommended prior to vaccination
with 10 liters of water, this volume theoretically 10,000 chicks should be
vaccinated, and count vaccinated chicks finalize. If the figure is very similar this
is the thing to do the day of vaccination.
5. For spraying a thin droplet, use the purple nozzle with green thread.
6. Turn the nozzle holder until the nozzle is facing the cages. To obtain a coarse
droplet use the nozzle lilac which thread is yellow. Turn the nozzle holder
until the nozzle is facing the cages.
7. If you do not want to vaccinate some row of the battery turn the nozzle holder
until the black color screw is facing the cages.
8. To check the quality of vaccination is essential to use the hydro-sensitive papers.
These papers should be placed in the front or roof of cages located at different
heights and at the beginning, middle and end of the hallway.
9. During vaccination you should stop all the ventilation system. It will start again
at 20 minutes after ending.
10. When it appears that the pressure starts to decrease gradually, the battery
is exhausted and needs to be put to charge by connecting the battery charger
plug into the housing. It is very important to observe the charge status indicator,
when the load level falls and the yellow light is activated, it should be stopped
and put to load.
PULMIC ANIMAL TRACK COMPONENTS
The principal components of PULMIC ANIMAL TRACK are:
Body of three nozzles and nozzle holders
• It is designed to facilitate the change of spray nozzles quickly and easily.
• It has three positions, two spray and one closure.
• It includes a valve that provides a non-drip closure.
14 14