Installation; Unico Boiler Master Installation Procedures; Choosing The Position Of The Unit; Unit Assembly - Olimpia splendid UNICO BOILER MASTER Instrucciones Para La Instalación, Uso Y Mantenimiento

2
2
2.1

UNICO BOILER MASTER INSTALLATION PROCEDURES

OLIMPIA SPLENDID
The electrical system must comply with the regulations and rating data in the technical sheet, with good grounding.
winter for models with heating pump) at the site of installation.
The more accurate this calculation is made the better the air conditioner will be able to do its job.
The user should try to limit high heat loads as much as possible as follows: glass doors and windows exposed to many hours of
- The wall on which the inside unit is installed must be sturdy and able to withstand its weight.
- It must be possible to leave room around the unit for any maintenance operations that may be necessary.
The air conditioner must be installed on a wall that communicates with the outside.
CAUTION: after determining the best place for installation as described above, check for the absence of other structures
or systems (beams, piers, pipes, wires, etc.) at the points where the holes are to be drilled, which would prevent drilling
the holes required to install the unit.
Check again to make sure there are no obstacles to air circulation through the holes to be drilled due to plants and their
leaves, slats or panelling, blinds, gratings or grids too dense, etc.).
WARNINGS
- it should not be placed under curtains;
- do not spray water or other liquids of any kind directly on the unit;
or anything that may even partially obstruct the grill itself;
2.1.3

Unit assembly

2.1.4

Warning

cannot be curved or bent.
2.1.5

Drilling the wall

Install the unit by drilling two holes (diameter of either 162 mm or 202 mm) in the wall as indicated in the drilling template.
The 202 mm holes will ensure best performance and utmost noiselessness.
insulating material from the air outlet pipe. Drill the wall using the proper tools to facilitate your job and prevent excess damage or
disturbance to your client. The best tools for drilling large holes in walls are special drills called core borers with very high twisting
torque and adjustable rotating speed depending on the diameter of the hole to be drilled. To prevent the creation of large amounts
:

INSTALLATION

2
39
UNICO BOILER