Features; Assembly; Operation - RIDGID R86036 Manual Del Operador

FEATURES

PRODUCT SPECIFICATIONS
SPEEDS
LOW (1) ....................................................0-1000 RPM
MEDIUM (2) ..............................................0-1800 RPM
HIGH (3) ...................................................0-2400 RPM

ASSEMBLY

WARNING:
If any parts are damaged or missing do not operate
this product until the parts are replaced. Use of
this product with damaged or missing parts could
result in serious personal injury.
If any parts are damaged or missing, please call 1-866-539-1710 for assistance.

OPERATION

WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict severe injury.
WARNING:
Always remove battery pack from the tool when
you are assembling parts, making adjustments,
cleaning, or when not in use. Removing battery
pack will prevent accidental starting that could
cause serious personal injury.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1. Failure to do
so could result in objects being thrown into your
eyes, resulting in possible serious injury.
APPLICATIONS
You may use this tool for the purposes listed below:
 Driving, tightening, and removing screws, nuts, and bolts
OVERLOAD PROTECTION
When the tool is forced or overloaded, the Li-ion battery pack
will automatically shut off the tool. To reset the tool, release
the trigger and resume operation. Do not force the tool.
Coupler ..................................................................... 1/4 in.
Impacts per minute ......................................... 0-1700 IPM
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this
product. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
HIGH TEMPERATURE PROTECTION
Li-ion battery packs are equipped with a high temperature
protection feature that automatically deactivates the tool
when it is overheated. To resume operation, allow the tool
to cool and then squeeze the trigger.
HYDRAULIC IMPACT TOOL
This impact driver uses oil to transfer the impacting motion,
resulting in quieter operation. Prolonged periods of heavy use
can cause the oil in the tool to overheat, resulting in slower
driving. If you experience decreased performance, allow the
tool to cool before resuming operation.
NOTE: When operating the tool in extreme cold tempera-
tures, it may be necessary to warm the oil before use. To
do this, pull and hold the trigger with no load for several
seconds before beginning operation.
INSTALLING/REMOVING BELT HOOK
See Figure 1, page 9.
The belt hook may be installed on either side of the housing.
 Align the hole in the belt hook with the hole in the housing.
 Install the screw to secure the belt hook in place.
 To uninstall, remove the screw then remove the belt hook.
VARIABLE SPEED SWITCH TRIGGER
See Figure 2, page 9.
The variable speed switch trigger delivers higher speed with
increased trigger pressure and lower speed with decreased
trigger pressure.
To turn the tool ON, depress the switch trigger. To turn it
OFF, release the switch trigger and allow the coupler to
come to a complete stop.
5 - English