ProMed tens 1000 s Manual De Instrucciones página 34

32
O
PERATING THE
Safety cover: The controls for pulse width, pulse frequency, mode
selection and modulation selection are protected by a safety cover.
To open cover 11, grip the upper end by the sides and lift open
the cover.
Intensity: The intensity regulators 2 are to be found on the upper
side of the unit and are used to set the intensity of stimulation. They
are also used to switch the unit on and off.
DE
Mode: The mode selector 5 is used to set the type of treatment.
The three available modes are: burst stimulation [Burst] (B), conti-
US
nuous stimulation [Continuous] (C) and modulated stimulation
[Modulated] (M).
FR
Pulse width (μs): The control knob 4 regulates the pulse width
(= the duration of individual impulses) for both channels.
IT
Pulse frequency (Hz): The pulse frequency knob 6 regulates
the number of pulses per second for both channels.
ES
Timer: With the aid of the timer control 7, you can set the duration
U
NIT
of TENS treatment. There are three possible settings: 15, 30 minutes
and C (continuous). Use the switch to select the desired setting.
Resetting the timer: To restart treatment or reset the timer,
simply switch the intensity regulator 2 into the OFF position, then
back to the ON position.
Mode functions: Burst mode (B) triggers two individual bursts
per second. In this mode, the pulse frequency is set at 100Hz
per second, while the pulse width is adjustable. In continuous
stimulation mode (C), impulses are transmitted continuously at the
selected settings for intensity, pulse frequency and pulse width. In
modulation mode (M), the pulse width set by the user is reduced
by 60%. This lower pulse width is maintained for 2 seconds before
returning to the original user setting, which is then maintained for
3.5 seconds. The cycle is then repeated. Intensity and pulse
frequency are adjustable by the user.