Taurus Professional 2 Manual De Instrucciones página 19

- Put the cable back in the cable
housing.
-Place the basket in the bowl.
-The basket handle may be left
affixed or it may be folded into the
basket by pressing the rods from the
side and twisting it round.
- Close the lid.
Cord housing
- This appliance has a cable com-
partment situated on its posterior.
Carry handle/s:
This appliance has a handle on the
side of the body, which facilitates
comfortable transport.
Practical recommendations:
- Fry a few pieces of bread to remove
the smell of used oil.
- For food with a high water content,
it is better and quicker to fry in two
lots with less food than in just one.
This will reduce the risk of splashes
and spillage.
- This will reduce the risk of splashes
and spillage. This system consists
of first frying the food until it is reaso-
nably well done and then frying again
using very hot oil to brown the food.
- Olive oil with a minimum acidity
level is recommendable for frying.
- Do not mix different oils.
- Wash potatoes before frying to stop
them from sticking.
Safety thermal protector:
- In the event of overheating, the
thermal safety mechanism will be
activated and the appliance will
stop operating. When this occurs the
Manual Professionals 2_3_4.indb 19
appliance should be disconnected
from the mains and left to cool. Then
press the rearming button, situated at
the back of the electrical circuit, with
the tip of a pen or similar in order to
reactivate the appliance (Fig. 1).
Cleaning
- Disconnect the appliance from the
mains and let it cool before underta-
king any cleaning task.
- Dismantle the appliance as follows:
Take off the lid
Remove the basket and take out the
electrical equipment
Remove the bowl
Carefully pour the used oil from the
bowl into a container (not the sink),
according to the regulations in force
for the treatment and disposal of
waste.
Pour soapy water into the tank to
degrease it.
- Except for the power unit and
the mains connection, all the parts
can be cleaned with detergent and
water or in washing up liquid. Rinse
thoroughly to remove all traces of
detergent
- Clean the electrical equipment and
the mains connection with a damp
cloth and dry. DO NOT IMMERSE IN
WATER OR ANY OTHER LIQUID.
- Clean the equipment with a damp
cloth with a few drops of washing-up
liquid and then dry.
- Do not use solvents, or products
with an acid or base pH such as blea-
ch, or abrasive products, for cleaning
the appliance.
15/11/11 12:16