Tabla de contenido
Idiomas disponibles
Idiomas disponibles
15
"UNIVERSAL INTERCOM" INTERCOM
The N-Com B601 system can be connected via Bluetooth to intercom systems of other brands or to N-Com
systems other than the "900" / "600" series
Important: N-Com systems other than the "900" / "600" series must be paired up to the N-Com B601 by
following the procedure "Pairing up the Universal Intercom".
15.1 Pairing up the Universal Intercom
The N-Com system can be paired up to the other intercom (from now on referred to as Intercom B) as if it was
a mobile phone.
Make sure the B601 is turned off.
Put the system in the "Configuration" mode: press the "n" key and keep it pressed for 4 seconds, until you
hear the voice announcement " Configuration Menu ".
Press the "" key until you reach the option " Universal intercom pairing ".
Put intercom B in the mobile phone pairing up mode (refer to the Intercom B manual).
After a few seconds, Intercom B will emit the confirmation beep.
N.B.: The system paired up using the UNIVERSAL INTERCOM is saved in the first available channel.
15.2 Universal Intercom Function
To turn on and off the audio between two helmets, proceed as follows:
From the N-Com B601 system:
Connect or disconnect Intercom B as you would for a regular N-Com intercom (chapter 14).
Intercom B may receive a dialing tone that must be answered with a phone reply command.
From intercom B
Press the " Voice call / Dial last number called " command.
To disconnect the intercom, press " Hanging up/rejecting a phone call " command.
Note:
During use of the UNIVERSAL INTERCOM, the B601 system keeps the connection active to the MAIN DEVICE
only (and not to the SECONDARY DEVICE).
The intercom system connected to N-Com B601 may not allow simultaneous connection to a mobile phone.
Only one system paired up in Universal Intercom mode can be stored.
1
Except for Bluetooth kit and Bluetooth kit2, which are not compatible
1
, thanks to the UNIVERSAL INTERCOM function.
19
Capítulos
Tabla de contenido
