Using The Micro Trimmer To Form The Eyebrows Or Remove Individual Facial Hairs - Silvercrest SBT 3.6 B1 Instrucciones De Uso

3) You can vary the cutting length to any one of the three settings. To do this, press
on the grooved area
pushed into the housing. Then push the eyebrow comb
position which corresponds to the desired length. Use the cutting settings on the
eyebrow comb
Setting
1
2
3
4) Push the on/off switch
5) Start by combing the eyebrows against the direction of hair growth.
6) Run the precision trimmer
eyebrow towards the bridge of the nose.
7) When you are finished with the treatment, push the on/off switch
direction to switch off the appliance.
Using the micro trimmer to form the eyebrows or remove
individual facial hairs
You can use the micro trimmer
1) Start by removing any other attachment from the hand element
Fit the micro trimmer
trimmer must be facing towards the side of the hand element
on/off button
2) Push the on/off switch
3) Move the micro trimmer
trimmer against the direction of hair growth. Ensure that the micro trimmer
always fully in contact with your skin.
4) When you are finished with the treatment, push the on/off switch
direction to switch off the appliance.
SBT 3.6 B1
on the eyebrow comb
as an orientation aid as well as the following table:
in the direction of the attachment.
with the eyebrow comb
to form the eyebrows or remove individual facial hairs.
on the hand element
is located (see chapter "Fitting/removing the attachments").
in the direction of the attachment.
in a careful and controlled manner. Always move the micro
so that the locking catch
Hair length after cutting
approx. 3 mm
approx. 6 mm
approx. 9 mm
from the outer end of the
. The slight curvature of the micro
to the cutting length
in the opposite
, if required.
on which the
in the opposite
GB │ MT │
59
is
is
■