Brinly SAT-40 BH Manual Del Propietário página 6

Step 3. ASSEMBLE TINES TO AXLE
3a) Place a 5/8" Flat Washer, Thick
(17) onto the Axle Assembly (6), then
slide it through the hole in End Panel
(5 right Side) and add another Flat
Washer Thick (17) if needed.
3b) Position the eleven Tines (7) and
twenty-two Spacer/Bearing Tubes
(27) onto the Axle Assembly (6) as
follows:
• Bearing, small end rst
• Aerator Tine
• Bearing, large end rst
Note: Round projections on Spacer/
Bearing anges must t into small
holes in aerator tines and into two
holes of opposite Spacer/Bearing
3c) Position one or two Washers (17
or 28) as needed to eliminate any
side-to-side movement and push
Axle Assembly (6) through hole in
the left End Panel (5) as far as possi-
ble. See layout below
Note: Tines must not move from side to side inside opening of end panels. If looseness exists, use additional 5/8"
5.
L-1643BH-
5
5/8" Washer (thick)
!
Tine and Spacer/Bearing Tube Layout
•
Spacer/Bearing Tube (small end rst)
•
Aerator Tine
•
Spacer/Bearing Tube (large ange rst)
Thick or Thin Washers (17 or 28) inside End Panel to eliminate any side movement.
ASSEMBLY
6
17
27
17
Qty. 4
WARNING : Gloves are required when handling
aerator tines. Tines have extremely sharp
points. Use caution when handling.
17 28
7
5/8" Washer (thin)
:
28
Qty. 2