Tabla de contenido
Spécifications du moteur et
exigences électriques (suite)
Protecteur de Surcharge Thermique
ATTENTION:
!
Ce compresseur est équipé
avec un protecteur de sur-
charge thermique de rajuste-
ment automatique qui sert à
couper le moteur s'il devient
surchauffé.
Si le protecteur de surcharge thermique
coupe le moteur (OFF) à maintes
reprises, vérifier pour les causes
suivantes.
1. Tension basse.
2. Calibre de fil ou taille de cordon pro-
longateur incorrect.
3. Filtre d'air obstrué.
4. Ventilation insuffisante.
5. L'appareil est utilisé avec une rallonge.
Voir le tableau de dépannage pour la
mesure corrective.
ATTENTION:
!
Le moteur doit se refroidir
avant le démarrage si possible.
Le moteur se relancera sans
avis si branché dans une prise
de courant et s'il est en marche
(ON).
Fr 10
2. With a marker, mark the edge where
the motor meets the base (the edge
farthest away from the pump).
3. Remove the belt guard bolt and nut.
4. Remove the front belt guard cover.
5. Loosen the four motor mounting
bolts.
6. The belt tension will pull the motor
toward the pump. Remove the belt
from the unit and set it on the ground.
7. Using the reference mark made in
step 1, move the motor approximately
1/4" past the mark (moving it away
from the pump).
8. Use a straight edge to make sure the
motor pulley is in line with the pump
flywheel. Tighten down the two motor
bolts furthest from the pump.
9. Put the belt on the motor pulley and
carefully roll it over the pump fly-
wheel. Do this by starting the other
end of the belt over the top of the
pump flywheel and turning the fly-
wheel counterclockwise.
Storage
1. When not in use, compressor should be
stored in a cool dry place.
2. Tanks should be drained of moisture.
Maintenance Schedule
Operation
Drain Tanks
Check Air Filter
Check Safety Valve
Blow Dirt From Inside Motor
Straight Edge
Touch Rim in Two
Parallel With Belt
Places
CAUTION:
!
When installing belt, use
caution to avoid injury to
fingers or hands.
10. Check belt tension. If still too loose,
loosen the front two motor bolts and
repeat steps 4-6. (When doing so,
move motor an additional 1/4" away
from pump).
11. When belt tension is good, tighten the
other two motor bolts.
12. Install the front belt guard cover.
13. Install and tighten the belt guard bolt
and nut.
3. Hose should be disconnected and hung
open ends down to allow any moisture
to drain.
Daily
Weekly
G
G
G
G
19
Tabla de contenido
