Sirona NITRASEAL Manual Del Operador página 25

Sirona Dental Systems GmbH
Operating Instructions NITRASEAL
Safety information
Electrical connection
61 79 761 D 3367
D 3367.201.02.01.02
1 Warning and safety information
surface of the chamber. This will allow the lubricant
in excess to filter out protecting the life of the instru-
ments.
9. If the autoclave does not have an efficient drying
system, the envelopes could remain damp. In this
case, it is recommended not to use the wrapping
technique, since there is a risk of damaging the ins-
truments. Consult your supplier to work out this pro-
blem.
Before using Your NITRASEAL Thermal Sealer, read
these safety instructions carefully. Non-compliance with
these standards could cause incidents or damage to the
appliance.
• Do not introduce fingers in the sealing area when the
machine is on.
• Do not introduce fingers under the protection cover
of the sealing area when the pressure lever is
lowered.
• Do not insert your fingers in the sliding surface of the
cutter.
• Keep the area around the sealer clean and dry.
• Never disassemble the NITRASEAL thermal sealer
when it is powered, since the high internal voltage
could be dangerous.
• In case of impossibility for disconnecting the power,
turn to OFF the breaker of the electrical switchboard
and place a sign Work in Progress on the breaker if
this is far and not visible by the person that is carry-
ing out the maintenance.
• Clean the appliance with a soft damp cloth after un-
plugging the power supply cable. Do not use sol-
vents on the product label.
• Check that the machine is electrically grounded in
compliance with the standard of the country of instal-
lation.
• Do not remove the back label and check that the
sealer is supplied with proper voltage value.
Check that the power data indicated on the label on the
rear side of the sealer corresponds to the values availa-
ble in the place of installation.
The equipment must be connected through the mains
cable to a socket provided with a ground connection in
compliance with the standard of the country of installa-
tion.
CAUTION
Do not bend the cable and do not place any object on it.
5