Tabla de contenido
Idiomas disponibles
Idiomas disponibles
4 Installation
4.1 Preliminary information
4
Installation
4.1
Preliminary information
4.2
To install the equipment follow these Instructions
10
Operating Instructions NITRASEAL
The NITRASEAL thermal sealer has been tested at the
factory.
On receiving the sealer control that the packing is whole
and keep it in case it should be shipped.
Open the packing and control that the delivery cor-
responds exactly to the technical specifications and that
no apparent damage is present.
In case of damage or missing parts inform the forwarder,
Sirona Dental Systems GmbH and its area agent imme-
diately.
1.
Place the sealer on a flat surface and with enough
room around to be ergonomically operative.
2.
Do not install the sealer next to sinks or the like, to
avoid contact with water and a consequent short-cir-
cuit of the electrical part.
3.
Do not place the appliance near heat sources.
4.
Install the machine in a room with normal air circula-
tion.
5.
Check that the power supply cable is not bent and is
free up to the plug.
6.
In case of model provided with roll-holder, insert the
supports of the roll-holder into their slots, then fit in
the roll on the supports.
7.
Insert the power plug, and the sealer is ready.
i
NOTICE
The first sealing operations could produce a slight smoke
and an unpleasant smell. This fact, due to substances
used on assembling the machine, is temporary and will
disappear after a few sealing operations.
Sirona Dental Systems GmbH
61 79 761 D 3367
D 3367.201.02.01.02
Capítulos
Tabla de contenido
