Troubleshooting - Sirona NITRASEAL Manual Del Operador

7 Troubleshooting

7
Troubleshooting
The power green light stays off.
The protection canvas on the resistor is burnished or burnt
The paper is nor clearly cut
The Sealer seals but the yellow light stays off
The heating element smokes or sends out a bad smell
The envelope sealing is not satisfactory
The envelope sealing is burnished (or burnt)
14
Problem Solution
Check the electrical plug
Check the fuses
Call the service
Call the service for the replacement
Replace the cutter or call the service
Call the service for the LED replacement
If the problem persists after the first few sealing operations,
call the service
Increase the temperature by turning the adjustment key
Decrease the temperature by turning the adjustment key
The sealer is provided with a device for temperature
control and a safety thermal fuse.
In case of mains voltage surge or improper use, the fuse
will burn or wear off so that it has to be replaced.
If the fuse is burnt, call the service for a replacement or
send the appliance directly to the nearest service centre.
We mark that the function of the fuse is for protecting the
thermal sealer from possible worse and more expensive
damage and that the fuse is a specific element required
by the safety standards.
i
NOTICE
Use only and exclusively original sare parts and apply to
an authorised technical service centre
Sirona Dental Systems GmbH is not responsible for any
faults or damage caused by appliances tampered with
by non authorised personnel or in case of fault of parts
that are not original.
Sirona Dental Systems GmbH
Operating Instructions NITRASEAL
61 79 761 D 3367
D 3367.201.02.01.02