Tabla de contenido
Idiomas disponibles
Idiomas disponibles
If you are missing hardware or have damaged parts after
unpacking grill, call 1-800-4-MY-HOME for replacements.
To order replacement parts after using grill, call:
1-800-4-MY-HOME
®
To make sure you obtain the correct replacement parts for
your Kenmore gas grill, please refer to the part numbers in
the part list.
Assembly Instructions
CAUTION: While it is possible for one person to
assemble this grill, obtain assistance from another
person when handling some of the larger, heavier
pieces.
1. Use the parts list to check that all parts have been
included.
2. Inspect the grill for damage as you assemble it. Do not
assemble or operate the grill if it appears damaged. If there
are damaged or missing parts when you unpack the
shipping box, or you have questions during the assembly
process, call:
For Assembly Questions, call 1-800-4-MY-HOME
8AM – 5 PM PST, Monday through Friday.
1. Bottom Panel
Loosen but do not remove the two 5/32" x 10mm screws that
are pre-assembled on either end of bottom panel trim piece
and remove the three ¼"x 15mm screws that are attached in
the middle. Secure the trim piece to the front of the bottom
panel by first inserting the end slotted holes over the two end
screws and pushing down. Tighten the screws. Then insert and
tighten the three middle screws.
Attach four casters to bottom panel using (16) ¼"x 15mm
screws with lock washer (AA) and (16) ¼" flat washers (EE).
Note: Q is swivel caster, R is swivel caster with brake.
stationary caster, F1 is stationary caster with brake.
Hint: For ease of caster assembly, turn bottom panel upside
down. Attach the two casters with brakes to the rear side of the
panel, opposite to the panel trim piece.
Important: Use only parts listed above. When ordering
parts, providing the following information:
1. Model #
2. Serial # (found inside the front panel of your grill)
3. Part Number (see PART# in chart)
4. Part Description
5. Quantity of parts needed
E1 is
R
Q
E1
F1
15
Tabla de contenido
