Precor RBK 615 Manual Del Propietario Del Producto página 95

Assembling the Exercise Bike
4. Route the flat, black base unit data cable to the left of the
5. Attach the twisted, red-and-black heart rate sensor cable
mounting bracket and about three-quarters of the way up
the left side of the console, as shown in the following
figure. Attach the base unit data cable to the
eight-conductor modular jack labeled LOWER BOARD
CONNECTION.
Figure 17: Routing the data and heart rate cables
to the four-pin connector on the heart rate circuit board at
the lower right corner of the console.
Note: The connectors can fit together in only one way.
There may also be a 10-pin connector labeled HEART
RATE on the console, but it is not compatible with this
equipment.
Important: If you are installing a Cardio Theater screen or
receiver, complete the Cardio Theater installation before you
reattach the console's rear cover.
33