Risk Of Injection Or Severe Cutting Injury; Risk Of Burns; Risk Of Bursting; Risk From Moving Parts - Mi-T-M Corporation HHM Serie Manual Del Operador

HAZARD
RISK OF INJECTION
OR
SEVERE CUTTING INJURY

RISK OF BURNS

RISK OF BURSTING

RISK FROM MOVING PARTS

6
IMPORTANT SAFETY INSTRUCTIONS
READ ALL SAFETY WARNINGS BEFORE USING HEATER MODULE
POTENTIAL CONSEQUENCE
Serious injury or death could occur
from high pressure spray penetrating
the skin.
Serious injury may occur from touching
the heat exchanger. This area can
remain hot for some time after the
heater module is shutdown.
Serious injury may occur from
a heater module malfunction or
exploding accessories if incorrect
system components, attachments or
accessories are used.
Serious injury or death may occur if
attempting to start the heater module
when the unit is frozen.
Serious injury may occur to the
operator from moving parts on the
heater module.
PREVENTION
Keep clear of nozzle and spray! Never put your hand,
fingers or body directly over the spray nozzle.
Never point the high pressure discharge spray at
yourself or anyone else.
This product is to be used only by trained operators.
Close supervision is necessary when used near
children.
Always keep operating area clear of all persons.
DO NOT allow children to operate this unit.
SEEK EMERGENCY MEDICAL CARE if the spray
appears to have penetrated the skin!
TREAT AS A SIMPLE CUT!!
High pressure hoses and fuel lines should be
inspected daily for signs of wear. If evidence of
failure exists, promptly replace all suspect hoses
and fuel lines to prevent the possibility of injury
from the high pressure spray. If a hose or fitting is
leaking, NEVER PLACE YOUR HAND DIRECTLY
ON THE LEAK.
NEVER operate the gun with the trigger wired in
the open position. To prevent accidental discharge,
the trigger gun should be securely locked when not
in use.
Before removing the spray nozzle or servicing the
unit, ALWAYS shut off the unit and trigger the gun
to release trapped pressure. (Even after you shut
off the unit, there is high pressure water left in the
pump, hose and gun until you release it by triggering
the gun.)
Never allow any part of your body to contact the
heat exchanger.
Do not leave unit unattended after shutdown until
it is completely cooled down as described in the
"SHUTDOWN" procedures listed on page 8 of
this manual.
Never make adjustments to the factory set
pressures.
Never exceed manufacturers maximum allowable
pressure rating of attachments.
Do not allow any hoses to make contact with heat
exchanger to prevent the possibility of bursting.
Avoid dragging the hoses over abrasive surfaces
such as cement.
Use only manufacturer recommended repair parts
for your heater module.
In freezing temperatures, the unit must always be
warm enough to ensure there is no ice formation. Do
not start the heater module if it has been transported
in an open or underheated vehicle without first
allowing the unit to thaw.
Never make adjustments to the unit while it is
connected to the power source.
Do not operate the unit without all protective
covers in place.
Follow the maintenance instructions specified in
the manual.
DO NOT
Operator's Manual