Worx WT545 Manual De Instrucciones página 8

Fig 1
B
Fig 2
08
Fig 3
Fig 4
Cordless Jigsaw
NA-WT545-M-051115.indd 8
OPERATING INSTRUCTIONS
1. BEFORE USING YOUR CORDLESS JIGSAW
Your battery pack is UNCHARGED and you must
charge once before use. Your battery pack will not be
fully charged until you have performed several charge
and discharge operations by charging & working with
your drill. After this your battery pack performance will
improve.
to use any other devices. Never insert or allow metallic
objects into your charger or battery pack connections be-
cause an electrical failure and hazard will occur.
A
2. HOW TO CHARGE YOUR BATTERY PACK (See
Fig 1)
1) Connect the battery charger to the power supply. The
red light will illuminate for 3 seconds and then it will go
out.
Note: If the red light flashes at a rapid rate (approx. 5
flashes per second), this means that the charger has
failed and must be replaced.
2) Fully insert the battery pack into the charger. With
a normal charging process, only the red light will illu-
minate to show charging has started. The red light will
remain on during the charging process. A discharged
battery at normal ambient temperature will take approx-
imately 1 hour to reach full charge.
Note: If the battery temperature is lower than 36ºF (0ºC),
the green light will flash slowly (approximately 1 flash
per second). Remove the battery and allow the battery
to warm-up to a charging temperature between 140ºF
(60ºC) and 95ºF(35ºC).
If the battery temperature is over 140ºF (60ºC), the green
light will flash rapidly (approximately 5 flashes per sec-
ond). Remove the battery and allow the battery to cool-
down to a charging temperature between 36ºF and 95ºF
(2ºC and 35ºC).
If the battery temperature is over 176ºF (80ºC), the charg-
ing process will be stopped, and the red light will flash
with a low speed (approximately 1 flash per second).The
battery must be replaced.
3) When the charging is complete, only the green light
will illuminate.
Note: When the battery is under charging and its volt-
age cannot reach 8V in 2 minutes, we consider the bat-
tery to be "dead" , and the red light will flash with a low
Note: Before using the tool, read the instruction
book carefully.
Warning: The charger and battery pack are specif-
ically designed to work together so do not attempt
WT545
2005-11-15 17:10:35