Machines With Card Programmer - Primus F/FS22 Manual De Uso

4.1. MACHINES WITH CARD PROGRAMMER

7. Check if the temperature setting on the thermostat (6) corresponds to the selected card.
8. Set the change-over switch (1) to the "0" position. Insert the (2) program card into the programmer, so
that the thick blue line is not visible.
9. Turn the change-over switch (1) to the "1" position and press the green button (3) to start the washing
programme.
– The light (9) is on if the programmer is in operation, and it is off during the water filling and heating
function.
– The light (8) is on when the machine is under current, i.e. the machine main switch and the room electrical
switchboard are on.
– The light (10) is on when the machine heating is switched on.
INTERRUPTION:
– If you want to interrupt the programme, move the change-over switch (1) to "0" position. To skip or repeat
a programme part, move the change-over switch to the "0" position by turning the hand wheel (4), move
the card forward or back and return the switch (1) back to the "1" position.
STOPPAGE:
– During operation you can stop the machine by pressing the red button (5). If you want to start the machine
again, press the green button (3).
– The EMERGENCY STOP button (7) can be used ONLY in case of an emergency situation (a risk of
injuries or machine damage).
– When the EMERGENCY STOP button (7) is pressed, all the machines functions are switched off. No light
will be on, the door remains locked and it is not possible to open it.
– To continue in operation, turn the EMERGENCY STOP button (located on the right side of the panel) in
counterclockwise direction and pull it out. Then press the START button (3).
10. The end of washing cycle will be reported by a sound signal. The light (9) will switch off (programmer
operation), and the green key of the door releasing will turn on.
Open the washer door as follows:
SOFT-MOUNT MACHINE TYPES 33 - 55 KG
– by turning the door handle down.
SOFT-MOUNT AND NON-CABINET MACHINE TYPES 22 KG
– by pulling the handle towards you
NON-CABINET MACHINES 35 - 43 KG
– by holding the lock releasing key and pushing the door handle to the right from the lock
11. After setting the change-over switch (1) to the "0" position, you can remove the programme card.
8 USER´S MANUAL PUB DATE: 05/00 507 329