Troubleshooting - Sony DWA-01D Manual De Instrucciones

Troubleshooting

If you encounter a problem using this adapter, use the following checklist to find a solution.
For any problems with the transmitter or receiver, refer to the operating instructions of the
respective device. If the problem persists, consult your Sony dealer.
Symptom
The DWR-S01D or
the WRR-855 does
not turn on.
There is noise in the
analog signal output
from the OUTPUT2
connector when the
adapter is connected
to the device that
accepts the analog
signal only.
No signal is output
from the OUTPUT2
connector when the
adapter is connected
to the device that
accepts the analog
signal only.
No signal is output
from the OUTPUT2
connector when the
adapter is connected
to the device that
accepts the digital
signal.
26 Troubleshooting
Meanings
The DWR-S01D or the
WRR-855 is not correctly
inserted into the slot of the
camcorder or this adapter.
The ANALOG AES/EBU
selector is set to AES/
EBU.
The tuner 2 of the DWR-
S01D is not turned on.
The WRR-855 is attached
to the adapter.
The ANALOG AES/EBU
selector is set to
ANALOG.
Remedy
Insert the DWR-S01D or the WRR-
855 until it is firmly and completely
in, and then secure it with the
mounting screws.
Set the ANALOG AES/EBU
selector to ANALOG.
Turn on the tuner 2 of the DWR-
S01D.
The WRR-855 is a single-channel
receiver. Thus, there is no signal
output from the OUTPUT2
connector.
Set the ANALOG AES/EBU
selector to AES/EBU.