Notes On Guarantee And Repair; Troubleshooting - Seiko 8R48 Instrucciones

NOTES ON GUARANTEE AND REPAIR

Please contact the retailer the watch was purchased from or SEIKO CUSTOMER
●
SERVICE CENTER for repair or overhaul.
Within the guarantee period, please present the certificate of guarantee to receive
●
repair services.
Guarantee coverage is provided in the certificate of guarantee. Please read carefully
●
and retain it.

TROUBLESHOOTING

Problem Possible causes
The watch stops The power supplied by
operating. the mainspring has been
consumed.
Even though you wear The watch is worn on
the watch every day, it your wrist only for a short
soon stops operating. period of time, or the
amount of arm movement
is small.
The date changes at 12 AM/PM is not properly set. Advance the hands by 12 hours.
o'clock noon.
18
Solutions
Turn the crown or swing the watch
to wind it up. The watch will start
operating. If the watch does not start,
consult the retailer from whom the
watch was purchased.
Wear the watch for an extended
period of time, or when taking off the
watch, turn the crown to wind the
mainspring.
Problem Possible causes
The watch has been left
in extremely high or low
temperatures for a long time.
The watch was brought
into
close contact with a
magnetic object.
The watch gains/loses
time temporarily.
You dropped the watch, hit
it against a hard surface or
wore it while playing active
sports. The watch was
exposed to strong vibrations.
The watch has not been
overhauled for more than
3 years.
The glass is blurred and Water got inside the watch
the blur persists for a due to the deterioration of
long time. the gasket, etc.
The stopwatch minute Time setting is done
hand and stopwatch while the stopwatch is
hour hand move while operating.
you are setting the
watch to the current
time.
• For the solution of troubles other than listed above, contact the retailer from whom the watch was
purchased.
Solutions
Normal accuracy will resume
when the watch returns to normal
temperature.
Normal accuracy will resume when the
watch is kept away from close contact
with the magnetic source. If this
condition persists, consult the retailer
from whom the watch was purchased.
Normal accuracy will not resume.
Consult the retailer from whom the
watch was purchased.
Consult the retailer from whom the
watch was purchased.
Consult the retailer from whom the
watch was purchased.
Push the crown back in to the normal
position. And then, stop and reset the
stopwatch. After that, if you wish to
set the time, follow the procedures in
"HOW TO SET THE TIME AND DATE"
section of this booklet.
19