Cleaning The Unit With The Aid Of The Blind Filter - Victoria Arduino VENUS CENTURY Manual Técnico De Empleo

A washing cycle is started for a group by pres-
sing the 2 key for that group. Once the
washing cycle is complete, it is possible to use
a rinse cycle on the same group by pressing the
1 key again. To perform the rinse cycle at a
later time, switch off the machine: the machi-
ne card will store any cleaning cycles that need
to be completed in its memory. In fact, the next
time that the machine is switched on, the
machine card will automatically open the
group cleaning status without it being neces-
sary to press the 5 keys
5 keys of the first and second group for 2
seconds will close the cleaning mode in the
event that there are no cycles still to be com-
pleted. For incomplete cycles, hold down the
2 keys for the groups still requiring rinsing.
Holding down the 5 keys
second groups for another 2 seconds will force
the cleaning mode to close, resetting any infor-
28
mation about incomplete rinses. If the clea-
ning cycle is completed, the 2 key
group will switch off and if no further rinses are
required, the machine card will exit the clea-
ning mode.
CLEANING THE BODYWORK
To ensure the machine maintains its characteri-
stics intact over the years, it must always be
kept perfectly clean.
Do not use detergent products, only a soft and
. Holding down the clean sponge dipped in water.
Any oxidisation of the bodywork is perfectly
normal as this is made from natural brass or
copper (depending on the version).
CLEANING THE UNIT WITH THE AID OF
for the first and THE BLIND FILTER
After replacing the standard filter in the filter-
holder with the blind filter provided, pour in
two teaspoons of specific detergent and then
of the fit the filter-holder in the unit and press the
continuous dispensing button.
After about 30'' stop dispensing and repeat
this last operation 3 times.
Finally, put the standard filter back in and make
a cup of coffee to be thrown away so as to
remove any remaining detergent residue.
CLEANING THE FILTER AND FILTER-
HOLDER
Mix two teaspoons of specific detergent in half
a litre of boiling water and soak the filters and
filter-holder in the solution for about half an
hour. Afterwards, rinse well under plenty of
running water.
Always use glass or stainless-steel containers
and keep the handles of the filter-holder out of
the detergent liquids.