Automatic Cleaning Cycle - Victoria Arduino VENUS CENTURY Manual Técnico De Empleo

ADJUSTING THE TURBOCREAM NOZZLE
(IF FITTED)
To increase/reduce the amount of air injected
into the milk from the TurboCream nozzle (and
therefore to increase/reduce the amount of
foam in the heated milk) proceed as illustrated
in fig. 1:
1 Loosen the stainless steel tube (1) as illu-
strated in fig. 2.A.
2 To increase/reduce the amount of air,
tighten (turning clockwise) or loosen
(turning anticlockwise) the Teflon tube
(2) as illustrated in fig. 2.B.
3 Tighten the stainless steel tube again.
fig.2.A
2
1
Remarks: By reducing or increasing the length
(tightening or loosening) the tube/Teflon tube
by a few fractions of a mm/mm, there is a
significant difference in the amount of foam in
the heated milk.

AUTOMATIC CLEANING CYCLE

Group automatic cleaning cycle
The cleaning cycle is comprised of two stages:
washing (with blind filter and puly caff deter-
fig.2.B
gent) and rinsing (with blind filter only). Each
stage lasts for 10 deliveries of 10 seconds each
at 5-second intervals. The cycles can be started
all together or individually for each group.
To access the automatic cleaning mode, first
switch the machine off and then on again, hol-
ding down the keys 5
looking at the machine from the front) and
fig.2
second (central) groups during the initial Flash-
test.
At the end of the Flash-test the 5
keys of all groups will begin to flash.
of the first (on the left
and 2
27