Troubleshooting; Technical Data - Urrea BAL24A Manual De Usuario Y Garantía

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Apagado
Apagado
Press
or
Stop
Stop
Technical safety card for using grease in
the wheel balancer:
Mobil grease XHP: 103
NLGI degree: 3
Type of thickener: Li-complex
Colour, appearance: Dark blue
Penetration on the processed item: 235
25º, ASTM D 217, mm/10
Dropping point, ºC, ASTM D 2265: 280
Viscosity oil base ASTM D 445, cSt: 100 @ 40ºC
Change of penetration consistency: 10 ASTM
D 1831 (established upon the rolling of the
greases), mm/10
4 spheres test, impression diam: 0.5 ASTM D
2266, mm
4 spheres test, welding load: ASTM 315 D
2509, kg
Test Timken OK load, ASTM D 2509: 45 lb
Stability of oxidisation bomb method: 35
ASTM D 942, drop at 100 hours, kPa
Corrosion prevention, ASTM D 1743: Aprobado
Emcor rust, IP 220, wash away with acid water: 0
Rust protection, IP 220-mod, wash away with
distilled water: 0
Corrosion on copper, ASTM D 4048: 1A
Resistance to water spray, ASTM D: 15
4049, % spray
Wash away with water, ASTM D: 5
1264, loss (weight%), @79ºC

TROUBLESHOOTING

ERROR INDICATION
CCC CCC
The result of measurement is beyond the ran-
ge.
OFF OFF
System gives the prompt when the STOP key
is interrupted accidentally.
ERR 01
When the guard is set enabled, press START
key without closing it or open the guard arti-
ficially while the wheel is in rotating measure-
ment. In either of these two cases, the balan-
cer is braked suddenly and gives the prompt.
Close the guard, or turn off the guard function
option in setting items. However, because the
laws and regulations of safety protection in di-
30
key, end operation.
fferent countries are not completely the same,
we suggest not turning off the guard function
option.
ERR 02
Prompt is given and measurement is stopped
when rotating speed is too low to meet the
basic measurement needs.
Problems of the electrical motor shaft or the
transmission belts. Check and adjust. Too light
load also results in this phenomenon, so please
adjust the load weight.

TECHNICAL DATA

VOLTAGE-FREQUENCY
PHASE
BALANCING TIME
ACCURACY
MAXIMUM WHEEL DIA.
RIM DIAMETER
TIRE WITDH
MAX. TIRE WEIGHT
110 V ~ 60 Hz
1~
10 s
1 g
28" (71 cm)
10" - 24"
1 1/2" - 20"
65 kg (163 lb)
Tabla de contenido
loading

Tabla de contenido