Tabla de contenido
Idiomas disponibles
Idiomas disponibles
cal staffs and it should meet the enforced regu-
lation and must be according to the following:
• Power on the data plate on the machine.
• Voltage decrease can not exceed 4% of the
rated voltage on the data plate when full load
(10% when start).
Operators must:
• Install the plug.
• install 30ma circuit breaker.
• install power cable fuse.
• provide with effective workshop electrical
connect to ground.
· Prevent the authorized operation and pull
out the plug to prolong the working life when
not use the machine.
· if the machine directly connected to the
power source through the power board not
the plug, we should use the qualified staffs to
operate.
WARNING: Perfect ground is necessary for
the correct operation. Do not connect the ma-
chine with air pipe, water pipe, telephone line
and the other unsuitable objects.
TRANSPORTATION
The balancer must be transported in the ori-
ginal package and be placed in the specified
position.
Use a forklift with corresponding capacity to
move the packed machine and the direction of
the forklift is shown.
OPENING PACKAGE
•
Check the package. If there are some pro-
blems, please do not open it, and contact the
supplier and the carrier at once.
• Make sure that the package is not damaged
and then open the protection carton and plas-
tic bag. Check the accessory case according to
22
the packing list. Check whether the machine
surface is in good condition and whether there
is loss or damage to the parts.
• Dismount the bolts on the base and make
the balancer steadily rest.
Please do not use the machine and contact the
supplier at once if there are some problems.
OPERATION INSTRUCTIONS
SELF-CHECK
When switched on, the system begins self-
check and then enters standard dynamic mode
measurement.
INSTALLING WHEEL
Choose the optimal cone for the center hole
and mount it on the balancer.
The method is preferable because it approxi-
mates to installing wheel on a real car.
WHEEL PARAMETERS INPUT
Unlike ALUS which needs 4 parameters, other
modes need 3 parameters.
Parameter values are shown in figure. (Dyna-
mic and static modes, ALU1-3 mode, motor-
cycle mode)
Tabla de contenido
