Tabla de contenido
Idiomas disponibles
Idiomas disponibles
5) Move Extension Table (and Front Rail) to Right
Release the table saw's rail lock lever (red lever located below saw's front rail) by pulling forward and up. Move the right side extension
table (and front rail) about 7 or 8 inches to the right. Push down on rail lock lever to hold the rail in place (fig. 5).
FIG. 5
6) Attach Wire Support Bracket
Place the new wire support bracket 5 so that its two (2) mounting holes are over the threaded screw holes in the left front side of the
saw's table 16 (fig. 6). Place the 2 new hex. head screws 6 through the bracket's screw holes and drive the screws tightly into the table
using the 4mm Hex. Wrench 10 (supplied with this kit).
16
5
FIG. 6
4
4
6
10
2
15
11
1
15
5.
Tabla de contenido
