Casio fx-9860GII SD Guia Del Usuario página 358

k Using Setup Wizard to Configure a Photogate Setup
Connection of a Vernier Photogate requires configuration of setup parameters that are
slightly different from parameters for other types of sensors.
To configure a setup for Photogate alone
u u u u u
1. Perform the first two steps of the procedure under "To configure an EA-200 setup using
Setup Wizard" on page 2-2.
2. On the "Select Sensor" screen, select [VERNIER] - [Photogate] - [Gate].
• This displays a screen where you specify whether Photogate is connected to the CH1 or
SONIC channel.
3. Press 1 to specify CH1 or 2 to specify SONIC.
• This causes a "Gate Status" screen to appear.
• "Open" means the photo path is not blocked, while "Close" means the photo path is
blocked.
• The gate status defines what Photogate status should cause timing to start, and what
status should cause timing to stop.
Open-Open ...... Timing starts when the gate opens, and continues until it closes and
Open-Close ...... Timing starts when the gate opens, and continues until it closes.
Close-Open ...... Timing starts when the gate closes, and continues until it opens.
Close-Close ...... Timing starts when the gate closes, and continues until it opens and
2-6
Using the Setup Wizard
then opens again.
then closes again.